Vertical chemical pump TPC and TPC-M

The free shaft design, without smooth bearing, together with the all-plastic construction, make the TPC and TPC-M the ideal solution for pumping highly corrosive fluids with high solids loads and for applications where it is not possible to discard dry operation. With its exceptional performance and depth setting, TPC is setting new standards. Whenever cost-effectiveness is a priority, TPC-M scores high without compromising operational reliability.

Vertical chemical pump TPC and TPC-M

The heavy-duty type TPC vertical cantilever pump without bottom bearing is designed with run-dry capabilities to pump solids-carrying acids, alkalis and chemically contaminated effluents directly from pump sumps, pump tanks, storage tanks or basins. The standard vertical setting depths of 1,000 and 1,800mm respectively can be extended to 3,400mm by a suction pipe.

Good reasons for a Munsch Pump TNP-KL

Numerically optimized hydraulics

The fluid dynamics of MUNSCH pumps are calculated, visualized and optimized using the latest numerical techniques (Computational Fluid Dynamics). The result is a hydraulic design with a virtually ideal flow profile.

This means:

    •    higher pump capacity at unchanged  differential head
    •    reduced energy costs
    •    improved suction behaviour through low NPSH requirements
    •    minimized wear in abrasive service conditions
    •    reduced running noise


Reduced lifecycle cost

The numerically optimized hydraulic design is a key factor in minimizing the lifecycle costs of MUNSCH pumps. Capital and maintenance costs are reduced through the selection of the best suited hydraulic design and optimum motor sizes. Smaller cable cross-sections and lower-rated motor breakers keep down installation costs. The high pump efficiencies directly translate into energy savings.

The pump adapts to the task at hand – impeller designs

MUNSCH has the right impeller design for your specific pumping application. Wear, suction behaviour and efficiency are key factors determining the choice of the impeller. The right combination of impeller (hydraulics), material and shaft seal is all-decisive for a successful pump design and long service lives. MUNSCH pumps are available with closed, semi-open and vortex impellers.

Pump characteristic

MUNSCH chemical pumps feature a steep performance characteristic. This means that the pumps can be adjusted exactly to the operating point.


Options

    •    Depth extension adjustment via suction tube
    •    Suction filter
    •    Single plate according to customer specifications
    •    Suction side flange position and design, according to customer specifications

Series Pump capacity [Q]  Differential head [H] Operating temperature [t] Operating pressure [p] Discharge nozzle Motor rating
TPC up to 600 m³/h up to 65 m from 0°C to +100 °C up to 10 bar DN 32 to DN 150 up to 45 kW
TPC-M up to 250 m³/h up to 65 m from 0°C to +100 °C up to 10 bar DN 32 to DN 150 up to 45 kW




Contact

Find the right product series by using the navigator.

Pump-Navigator

Don't miss any news. Subscribe to our newsletter.

Register now